04-26-2006 Additions - Laserfiche WebLink

Home Browse Search

700 .082 .042 800 .091 .046 900 .099 .050 1,000 .108 .054 1,100 .116 .058 1,200 .125 .064 1,300 .133 .068 1,400 .142 .072 1,500 .150 .075 For average unit floor areas less than shown, use the floor area ratios listed for 200 square feet. For areas greater than shown, use the ratios listed for 1,500 square feet. For recreational camping areas, use the ratios listed at 400 square feet. Manufactured home sites in recreational camping areas shall use a ratio equal to the size of the manufactured home, or if unknown, the ratio listed for 1,000 square feet. c. Multiply the suitable area within each tier by the floor area ratio to yield total floor area for each tier allowed to be used for dwelling units or sites. d. Divide the total floor area by tier computed in Item C above by the average inside living area size determined in Item A above. This yields a base number of dwelling units and sites for each tier. e. Proposed locations and numbers of dwelling units or sites for the commercial planned unit development are then compared with the tier, density and suitability analysis herein and the design criteria in Section 917.110.E of this Ordinance. 3. Density Increase Multipliers. a. Increases to the dwelling unit or dwelling site base densities previously determined are allowable if the dimensional standards in Section 917.020 of this Ordinance are met or exceeded and the design criteria in Section 917.110.F of this Ordinance are satisfied. The allowable density increases in Item "b" below will only be allowed if structure setbacks from the ordinary high water level are increased to at least fifty (50) percent greater than the minimum setback, or the impact on the waterbody is reduced an equivalent amount through vegetative management, topography, or additional means acceptable to the City of Little Canada and the setback is at least twenty-five (25) 917 -15 - 2 8 -