03-25-2026 Council Packet - Laserfiche WebLink

Home Browse Search

property lines. Applicant Response: Meets requirement. An Engineering Letter for Fall Zone has been provided by a certified and licensed professional engineer stating that the towers fall zone is within a radius of 38’. Minimum zoning district setbacks are Front: 50’, Rear: 20’, and Side: 10’. The proposed Wireless Facility meets the minimum zoning district setbacks with setbacks of Front (east): 294’-11 5/8”, Rear (west): 271’-4”, Side (north): 38’-9 15/16”, Side (south): 64’-11 7/16”. See Exhibit C (Construction Drawings) and Exhibit D (Engineering Letter for Fall Zone). D.Use of City Tower Site Preferred. Commercial antennas and towers, regardless of height or size with the exception of satellite dish antennas shall connect to and use the City Tower Site(s) if use of such facilities is technically feasible. Certification by a professional radio frequency engineer is required to demonstrate that a particular tower site is not technically feasible when antenna site is proposed. Applicant Response: Meets requirement. The applicants proposed Wireless Facility is necessary to meet coverage demand as there are no other towers or usable antenna support structures in the area that can be used to resolve the service gap in this area. See Exhibit E (Radio Frequency Engineer Letter). E.General Standards. The following standards shall apply to all cellular telephone, public utility, microwave, radio and television broadcast transmitting, radio and television receiving, satellite dish and short-wave radio transmitting and receiving antenna and towers: 1.All antennas and towers shall be in compliance with all City building and electrical code requirements and as applicable shall require related permits. Applicant Response: Meets requirement. See Exhibit C (Construction Drawings). 2.Towers shall be certified by a qualified and licensed professional engineer to conform to the latest structural standards and wind loading requirements of the Uniform Building Code and the Electronics Industry Association. Applicant Response: Meets requirement. The structural analysis for the tower and foundation will be provided at the Building Permit stage and will meet the conditions noted above in this section. See Exhibit C (Construction Drawings). 3.With the exception of necessary electric and telephone service and connection lines approved by the Issuing Authority, no part of any antenna or tower nor any lines, cable, equipment or wires or braces in connection with either shall at any time extend across or over any part of the right-of-way, public street, highway, sidewalk, or property line. Applicant Response: Meets requirement. No part of the proposed Wireless Facility will extend across or over any part of the ROW, public street, highway, sidewalk, or property line. See Exhibit C (Construction Drawings). 4.All signal and remote-control conductors of low energy extending substantially horizontally above the ground between a tower or antenna and a structure, or between towers, shall be at least 8 feet above the ground at all points, unless buried underground. Applicant Response: Meets requirement. See Exhibit C (Construction Drawings). 5.Every tower affixed to the ground shall be protected to discourage climbing of the tower by unauthorized persons. Applicant Response: Meets requirement. The applicant is proposing to install a six (6) foot chain-link security fence around the Wireless Facility to prevent any unauthorized access to the tower site. See Exhibit C (Construction Drawings). 6.All towers shall be constructed to conform with the requirements of the Occupational Safety and Health Administration. Applicant Response: Meets