09-28-1988 Council Agenda - Laserfiche WebLink

Home Browse Search

918.050. LOT REQUIREMENTS AND SETBACKS. The following minimum requirements shall be observed in an "I -P" District, subject to additional requirements; exceptions, and modifications set forth in this Ordinance. A. Lot Area: B. Lot Width: C. Setbacks: 40,000 square feet 150 feet *I. Front Yards: Not less than forty (40) feet. *2. Side Yards: Not less than fifteen (15) feet on any side, nor less than forty (40) feet on the side yard abutting a public street. * *3. Rear Yards: Not less than twenty (20) feet. 4. Yards abutting residentially zoned property: Not less than Forty (40) feet on any yard abutting residentially zoned property. D. Landscaping. All lots in on "I -P" District shall have not less than twenty -five (25) percent of the lot area dedicated to landscaped green area in compliance with Section 903.020.G. of this Ordinance. Landscape plans must be submitted to and approved by the City Council. E. Lot Coverage. No building or combination of buildings in the "I -P." District shall exceed thirty -five (35) percent of the total lot area on which it is located. 918.060. BUILDING REQUIREMENTS. A. Height. No building shall exceed forty (40) feet in height, except as provided in Section 903.040.C. of this Ordinance. 8. No pole type or engineered steel buildings shall be allowed. C. All plats and building plans shall be reviewed and approved by the Council before issuance of a building permit. * "D. 1. All buildings in the "I -P" District shall be constructed of solid wall masonry, pre -cast concrete, aggregate panels, or wood frame masonry veneer (excluding stucco). Wood and metal exterior may be allowed as part of window and door frame or fascia treatment of the exterior wall facing design. 2. The following materials, in conjunction with the materials in 918.060.D.1., may be used to a maximum of twenty -five (25) percent of the proposed area if it is coordinated into the architectural design of the structure. a. Wood, provided the surfaces are finished for exterior use and wood of proven, exterior durability is used, such as cedar, redwood, cypress. b. Curtain wall panels of steel, fiberglass and aluminum, (nonstructural, nonload bearing) and finished with a durable nonfade surface and their fasteners are of a corrosion resistent design, c. Gloss curtain wall panels. d. Stucco. 3. The proposed building maintains the quality and value intended by the Ordinance. 4. The proposed building is compatible and in harmony with other structures within the district. 5. The provisions of Section 921 .010.C. of this Ordinance ore considered and the request is found to comply with these criteria. *Amended by Ordinance No. 261, dated August 14, 1985 "Amended by Ordinance No. 262, dated August 14, 1985 Page 79 82 C