2018-002 Council Ordinances - Laserfiche WebLink

Home Search

ATTACHED TO AND MADE A PART OF CONSENT TO IMPROVEMENTS DATED ,2017,BETWEEN XCEf ENERGY and PIETTE EXHIBIT"A" AUTHORIZED USE: Deck and Porch at 6743 Pahn Street,Lino Lakes,MN 55038 SCOPE OF PROJECT. This project consists of a new 2nd story deck,stairway and porch between structures 458-459,portions of which will be located within the Xcel Energy Easement Area. The exact locations of the improvements within the easement are shown on Exhibit "C", attached hereto. The deck will be 25 feet wide and extend 14 feet from the face of the existing house,with a 12 inch overhang on the porch.The porch height shall not exceed 20 feet above the existing grade to the Northeast and Southwest roof edges.The peak of the ridgeline shall not exceed 25 feet above the existing grade.For reference,the existing grade on-site is 923 feet. The hereinbefore described dimensions of said improvements are depicted on Exhibit"B", attached hereto. The proposed project meets Xcel Energy's standards,provided the following conditions are adhered to: (1) Grade change within Easement Area. The ground elevation within the Easement Area shall not be increased above the existing grade. Stockpiling of soil and/or material within the Easement Ares will not be permitted.Any proposed grade changes required for the site driveway must be reviewed and approved by Xcel Energy prior to the start of construction. (2) Clearances to equipment and workers. A working clearance of 10 feet between the electrical conductors and any cranes or digging equipment used at �\ conductor elevation in or near the easement and a clearance of 10 feet to the physical proximity of workers must be maintained at all times. In addition, any construction near the transmission line(s) shall comply with all OSHA Safety Clearances. If this clearance cannot be maintained, the contractor or developer must arrange for a line outage by calling Xcel Energy's System Control department. Adequate advanced notice must be provided in order to schedule a line outage,if an outage is available. The preceding two paragraph(s)must be included in a prominent location on the plan sets and specifications given to contractors. (3) Building on Easement Area. There shall be no additional permancnt or temporary buildings allowed within the easement area, without prior written approval from Xcel Energy. (4) Fuel and refueling on casements. There shall be no fuel tanks stored or refueling of vehicles and equipment within the easement. (5) Grounding. Metallic structures must be properly grounded. The seine working clearance criteria as stated in paragraph(2) also applies,for equipment used to erect and install light standards,sign boards,etc. Any metallic structure,pole,wire or item placed in the vicinity of a high-voltage transmission line will have the potential to become electrically charged due to electrical induction. The development of an electric charge results in a potential difference between the metal installation and the ground,which can result in electrical shocks when the item is touched.Placement of such metallic installation should take into consideration the shock potential during the;construction, intended use AND future maintenance activities. Items which become charged must be connected to a grounding rod or grounding system to prevent shocks. (6) Notification. Prior to the start of constriction and following project completion, the requestor or contractor must notify Xcel �� Energy.Please contact Chad Peterson at(612)330-7825,or by email at cluad.t.peterson asxceleneray.com