08-01-2022 Council Work Session Packet

Home Search

The rear facing center seating shall include a seat frame which is located and installed behind the engine tunnel. The seat frame shall measure 46.15 inches wide X 12.00 inches high X 15.88 inches deep The seat frame shall be constructed of 0.19 inch thick Marine Grade 5052-H32 smooth aluminum plate. The seat box shall be painted with the same color as the remaining interior. SEAT FRAME REAR FACING CENTER STORAGE ACCESS The rear facing center seat frame shall include a storage access opening which shall measure 32.00 inches wide X 8.75 inches high to allow access within the seat frame for storage. A solid access door shall be provided at the opening. CAB FRONT UNDERSEAT STORAGE ACCESS The left and right under seat storage areas shall have a vented aluminum hinged door with non -locking latch. SEAT COMPARTMENT DOOR FINISH All underseat storage compartment access doors shall be coated with the same color paint as the primary exterior color or the lower exterior color of the cab if a two-tone. WINDSHIELD WIPER SYSTEM The cab shall include a triple arm linkage wiper system which shall clear the windshield of water, ice and debris. There shall be two (2) windshield wipers; each shall be affixed to a radial arm. The wiper motor shall be activated by an intermittent wiper control located within easy reach of the driver's position. ELECTRONIC WINDSHIELD FLUID LEVEL INDICATOR The windshield washer fluid level shall be monitored electronically. When the washer fluid level becomes low the yellow "Check Message Center" indicator light on the instrument panel shall illuminate and the message center in the dual air pressure gauge shall display a "Check Washer Fluid Level" message. CAB DOOR HARDWARE The cab entry doors shall be equipped with exterior pull handles, suitable for use while wearing firefighter gloves. The handles shall be made of aluminum with a chrome plated finish. The interior exit door handles shall be flush paddle type with a black finish, which are incorporated into the upper door panel. All cab entry doors shall include locks which are keyed alike. The door locks shall be designed to prevent accidental lockout. DOOR LOCKS The cab entry doors shall include a CAN based electronic door lock system which shall include two (2) external keypads, one (1) located on the left side next to the front grab handle and one (1) on the right side next to the front grab handle. There shall be one (1) red rocker switch provided on the inside of each front cab entry door to actuate the cab door locks. Each door lock may also be manually actuated from the inside of the cab by means of a red knob located on the paddle handle of the respective door.