Laserfiche WebLink
S P0178-2007 <br />NACE International gratefully acknowledges the contributions of the following companies in the <br />preparation of the welding samples and the fabrication of the die from which the plastic replicas <br />have been molded: <br />Ausimont USA, Inc.,12> Thorofare, NJ <br />CenterPoint Energy,(3) Houston TX <br />S.G. Pinney & Associates, Inc.,i4i Port St. Lucie, FL <br />The Sherwin-Williams Company,(5) Cleveland, OH <br />NACE also gratefully acknowledges the assistance of KTA-Tator Inc.,(6) Pittsburgh, PA, in <br />developing the weld pattern that was used to mold the plastic replica of weld samples. <br />In NACE standards, the terms shall, must, should, and may are used in accordance with the <br />definitions of these terms in the NACE Publications Style Manual, 4th ed., Paragraph 7.4.1.9. Shall <br />and must are used to state mandatory requirements. Should is used to state something considered <br />good and is recommended but is not mandatory. May is used to state something considered <br />optional. <br />(2)Ausimont USA, Inc., 10 Leonards Lane, Thorofare, NJ 08086. <br />(3) CenterPoint Energy, P.O. Box 1325, Houston, TX 77251-1325. <br />(4) S.G. Pinney & Associates, Inc., Corporate Office, 1326 S.W. Biltmore St., Port St. Lucie, FL 34983. <br />(5)The Sherwin-Williams Company, 101 Prospect Avenue N.W., Cleveland, OH 44115. <br />(6) KTA-Tator, Inc., 115 Technology Drive, Pittsburgh, PA 15275. <br />ii NACE International <br />