Laserfiche WebLink
4 <br /> <br />Front yard 25 25 25 <br /> <br />Single-Family Detached and <br />Attached - 25 <br />Multifamily Dwellings: LEC <br />105.12.830(a)(6)a <br />Non-Residential Uses: LEC <br />105.12.830(b) <br />Single-Family Detached and <br />Attached - 25 <br />Multifamily Dwellings: - 25 <br />Non-Residential Uses: - 25 <br />Interior Side Yard: <br />Principal building 10 10 10 10 e <br />Attached garage or accessory structure 5 5 5 5 <br />Corner side yard 15 15 15 0 f <br />Rear yard 20 20 20 10 g <br />Notes to Village Districts Table: <br />a. No development may exceed the residential density range as specified in the comprehensive plan for the <br />corresponding land use category. <br />b. Two-family units may be side-by-side with a party wall between them (twin) or located on separate floors in a <br />building on a single lot (duplex). The per-unit measurements in this table apply to twin units, whether on a single <br />lot or separate lots. The standards for single-family detached dwelling shall apply to a duplex containing two <br />vertically-separated units on a single lot. <br />c. In the case of single-family attached dwellings that are not situated on individual lots, minimum lot size shall be <br />applied to each unit as a measure of density; i.e., one unit per 2,500 square feet. This standard is also used for <br />multifamily dwellings. <br />d. Buildings up to 45 feet in height may be permitted as part of a PUD in the VMX district and V-MDR districts. <br />e. Side yard setbacks in the VMX district apply only along lot lines abutting residentially zoned parcels or those <br />parcels with residential uses as the sole use. <br />f. Corner properties. The side yard facade of a corner building adjoining a public street shall maintain the front <br />setback of the adjacent property fronting upon the same public street, or the required front yard setback, whichever <br />is less. If no structure exists on the adjacent property, and provided required setbacks are not otherwise stated herein, <br />the setback shall be shown in the table.