Laserfiche WebLink
LAKE ELMO CITY COUNCIL MINUTES AUGUST 20, 1985 Page 4 <br />The five actions are listed in Bohrer's letter dated August 20, <br />1985 to the City Council. <br />1. Stop all pumping within the City. <br />2. Establish a moratorium in new development within the Legion <br />Pond Subwatershed. <br />3. Install a storm sewer from the Legion Avenue culvert to <br />existing storm sewer in Lake Elmo Avenue. <br />4. Add fill to the City -owned drainage easement to match filling <br />done by residents on either side. <br />5. Check monitoring wells for ground water elevations. <br />Moratorium <br />The City could impose a moratorium on building to prevent <br />additional runoff from entering the pond, but our investigations <br />have found the pond level is supported by the groundwater table <br />and surface runoff is a minor contributor to the pond level. The <br />drainage area has not been altered over the years and no new <br />houses have been built since the Legion Avenue homes were built in <br />late 1960's and early 1970's, yet the pond has continued to rise. <br />Storm Sewer <br />It was suggested that a storm sewer be constructed on 30th Street <br />and Legion Avenue to drain the Legion Avenue culvert into the <br />County storm sewer system in Lake Elmo Avenue. A review of old <br />construction plans indicates culvert invert in Legion Avenue to be <br />elevation 890 and invert elevation of storm sewer in Lake Elmo <br />Avenue at 30th Street to be elevation 900; therefore, Legion <br />Avenue will not drain into Lake Elmo Avenue. <br />Added Fill <br />It is estimated that 300 cubic yards of fill would be required in <br />the drainage easement to match the filling done by residents on <br />either side. The estimated cost in labor, material, and equipment <br />to do this work with City forces is $3,500. <br />Monitoring Wells <br />On August 19, 1985, monitoring wells 2 and 3 were checked for <br />groundwater elevation. Monitoring Well No. 1 was not able to be <br />checked because the cap was rusted on tightly. The following is a <br />comparison of results obtained now and 1980: <br />