HomeMy WebLinkAboutItem 11 - Final 21 Oct 13 12229-TGG LAKE ELMO “Where Craftsmanship, Service, & Expertise Equals Value For You!”
61381 US Hwy 12 • Litchfield, MN 55355
Toll Free: 888.805.5971
Ph: 320.693.7900 • Fax: 320.693.7921 www.towmaster.com
Equipment Specifications
Ref: Quote # 12229-TGG LAKE ELMO MODEL: 106 EDGE-RS DIMENSIONS: 10'6" long x 96" wide O.D. FRONT PANEL:
46" high, 7ga Stainless Steel const, reinforced top rail with inclined mount & rubber flap seal. SIDES: (Struck)
36" high, 7ga Stainless Steel panels, 18" radius corners, fully boxed top rails, w/inv angles full length, Board pockets front
and rear/DELETED, full depth 7 ga Stainless Steel rear corner posts, dual 2-line sander manifold(s) @ RH & LH REAR
corner post, Removable 3-1/2” Bustin (Painted Carbon Steel) walk rail full length both sides, TMTE "FLIP-A-Way" Stainless
Steel access ladder - LH REAR, with interior step & upper grab handle. TAILGATE:
36" high, 3/16" HARDOX-450 Interior main panel, 10 ga Stainless Steel outer reinforcings, 3 panel design, 1-1/4" dia bottom pins, 1" thick upper hinges w/bushings & 1-3/4” dia pins, Lever top-pin release system, 3/8" alloy spreader chains,
steel latches, airtrip ready linkage. (See also “SANDER” for flow plates type) FLOOR: 1/4" HARDOX-450 steel.
UNDERSTRUCTURE:
W8" x 13.0#/ft struct (I-BEAM) longsills, w/8" rear bolster. PREP/PAINT: Exterior Acid Washed and left in Stainless Mill Finish. Underside & Carbon Steel parts blasted, Seam-Sealed, Urethane
primed and painted w/Gloss black Polyurethane. LIGHTS/WIRE: (D-Housings) FMVSS 108 compliant, rubber mounted LED clearance lights, LED Cluster of 3, w/Factory sealed wire harness, Ground
strap, Stainless Steel STROBE/ STOP-TAIL-TURN /BACKUP light provisions in corner posts (see D.O.T. Warning Light System below). MUD FLAPS:
Rear of rear tires, attached to mounts. (SEE ALSO FENDERS) CABSHIELD: (Stationary) 1/2 type, 24" Stainless steel cabshield Canopy, Stationary “Free-Standing” style, Hot-Dipped Galvanized frame, w/2vert
shovel holders, Adj tubing strobe brkts, reservoir mounting brkts, & Full window, Installed. Canopy Acid Washed/blasted, primed, and painted]. (SEE ALSO STROBE SYSTEM) HOIST:
Omaha Standard-Palfinger Model: 720DH Overhang: (see truck layout form), Dump angle: 50°, Double acting, W/solid block rear hinge point & OSHA approved safety prop.
“Where Craftsmanship, Service, & Expertise Equals Value For You!”
61381 US Hwy 12 • Litchfield, MN 55355
Toll Free: 888.805.5971
Ph: 320.693.7900 • Fax: 320.693.7921 www.towmaster.com
PUMP:
Front frame mounted, Engine crank-shaft driven, LS type. Make: Force America Model: FASD34L, 4.67, Including an H.P. ball valve on pressure outlet.
VALVE:
Make: Force America Model: Add-A-Fold MCV-ISO, 9 function, LS type. Providing control for: Box Hoist, Plow Lift, Plow Angle, Wing Toe, Wing Heel, Wing Push-Bar, Scraper Lift, Auger, & Spinner, Including Relief on ON HOIST, Float on
PLOW, Wing-Loc valve on wing heel (by Falls)] & external valve Enclosure. SANDER VALVE/CONTROL: (Integrated) Force America model SSC-6100 w/auger reverse ground-based closed loop electronic control] Internally mounted in main
control console. CONTROLS: (Electronic) Force ULTRA- 4 type remote electronic controls, Adjustable Arm-mounted off of the driver’s seat. (Note: Control will move
up and down with air seat) RESERVOIR & FILTRATION: (Cabshield) 30 gal Stainless Steel, cabshield mounted w/sight-level gauge, filler-breather, magnetic drain plug, 100 mesh suction
screen, gate type shut off valve, & quick drain valve with remote hose. 12 volt DC Low oil indicator system included. Return line type, IN-TANK mounted - hydraulic oil filter w/replaceable element, & 12 volt condition indicator installed,
Filled with DEXRON III hydraulic oil. PLUMBING: 2" suction line, 1" main pressure line, 1-1/4" return line, balance to match component port sizing requirements. All swivel
fittings are 37° JIC or dry-seal type. TOOL BOX: 18” x 18” x 24” long, aluminum construction, with diamond plate door, Twist handle latch & weather seal, installed on LH frame rail, with angle-iron mounts. CAMERA SYSTEM: Brigade Electronics model VBV-750-BM-010 camera system (max 3 inputs), including 7” LCD color screen (in cab), infrared “night vision” camera, & all cables, Installed complete for Wing operation/Reverse viewing. FENDERS: MINIMIZER model: MIN2260 black poly fender set, w/bolt-on frame brackets, Installed.
VIBRATOR:
Cougar model: DC-3200 12 volt D.C., Installed on Front center underside of body, w/Switch mounted in cab (See CAB LAYOUT Drawing) TAILGATE TRIP:
3-1/2” x 10” air cylinder, Solenoid air valve, w/piping and fittings, & installed ROADWATCH: RWSS ROAD WATCH system installed with Force America cable hooked up to 6100 Salter control. REAR HITCH: Pintle Height 24”
3/4" Steel pull plate w/bracing to truck frame, Safety chain D-rings, Premier 370 air-cushion Pintle hook, with Transfer of 7 round female electrical socket, & Transfer of air glad-hand connections to rear plate.
“Where Craftsmanship, Service, & Expertise Equals Value For You!”
61381 US Hwy 12 • Litchfield, MN 55355
Toll Free: 888.805.5971
Ph: 320.693.7900 • Fax: 320.693.7921 www.towmaster.com
D.O.T. WARNING LIGHT SYS: (w/Wing TIR) TMTE-1-5 (custom built by Whelen) warning light system, consisting of: (2) 23H 3-light LED Micro-Edges, (2) 5M-400
Linear Super-LEDs, (2) Side TIR3 LEDs, 400 Max B-T-T LEDs, & (2) 400 L.E.D. Backup Lights, in Stainless Steel Housings. System also includes (1) LED Wing Plow light, and (2) 4" dia LED work lights (sander & wing). Installed
complete with cables, & switches in cab. Note: Separate switching of Micros, Rear Body Lights, & Wing Warning Light SNOWPLOW LIGHTS: Combo HOH headlight w/turn signal, Mirror mounted on Std Alum brackets, w/OEM Selector switch dash mounted. UNDERBLADE: (SDL App) Falls model IB-11A Fixed angle 11', RH discharge, set forward of standard location, 1" thick moldboard, all mtg hdwe &
plbg, w/Pressure gauge cab mounted. Nitrogen accumulator cushion & auto reset w/External adj pressure reducing/relief valve included. Blade auto lift in reverse system provided and installed SNOWPLOW:
Falls Model PR1243 SPRING TRIP Power Reversible Straight Moldboard snowplow, complete with all std equip, SPRING Trip Mechanism, Rubber Snow Flap, End Markers & plow push unit for Falls X4 PIN AND LOOP hitch system. Painted Falls std Gloss Black paint color. Shipped loose in dump body. .
PLOW HITCH:
Falls Model 44XB2 PIN AND LOOP heavy duty hitch system, complete with all std features, all mtg hdwe, wing post provision, Std plbg, S.A. lift cylinder, & Spring Return. Installed and painted gloss black. SNOW WING:
Falls Model SDL9RL REAR LIFT All Hydraulic Patrol Style snow wing, Scraper Discharge mounted, complete with all std features, Nitro-Cush Hyd Pushbar, all mtg hdwe & Std plbg, installed complete, and Moldboard painted Falls std “BLACK” paint color. SANDER: (Salt Special) Falls Model #1ASD-6CDLMSS Salt Special Stainless Steel under-gate sander, 6" dia, 6” pitch 3” inner tube auger,
External-Removable, STAINLESS Steel side spill plates, LH poly spinner ass’y, Extra “anti-Salt” plate, plbg, Std couplers, & mtg hardware, Installed. NOTE: Plumbing connections at RH & LH Cornerpost Manifolds. PRE-WET SYSTEM:
Varitech/Force model LDS-TMR110 EGF-ON/OFF gravity feed; pre-wet system, complete with mounting brackets, & piping Fitted to body Sides, and Installed with all wiring & lines. Manual ON-OFF over-ride switch mounted in cab WARRANTY: 24 Months (from In-Service/Invoice Date), on all components, equipment, and services sold by and installed by
TOWMASTER (or its assigned subcontractors). This includes: Dump Body, Hoist, Hydraulic System, Controls, Lighting, & Snow Fighting Equipment. Whelen All L.E.D. light systems carry 5 yr unconditional warranty, with the exception for breakage or water damage due to breakage.
Specifications Accepted by: ___________________________________________________ Date: _________________