Agenda Packets - 2020/01/13 - Laserfiche WebLink

Home Browse Search

1 See Chapters 1010, 1301 and 1302 of this Code for drainage and flood control regulations. 630665v12MU210-54 6 conditioned upon compliance with all requirements deemed necessary to preserve neighborhood aesthetics or protect the health, safety and welfare of neighboring landowners and the future residents within the subdivision. Subd.3.Subsequent Approval: a.Subsequent approval will be required of the engineering proposals pertaining to water supply, storm drainage, sewerage disposal and other utilities. b.Subsequent approval of the preliminary plat will be required by other public officials having Jurisdiction prior to the approval of the final plat by the Municipality. Subd.4.Flooding or Poor Drainage Facilities21: No plan will be approved for a major or minor subdivision which covers an area subject to periodic flooding or which contains extremely poor drainage facilities and which would make adequate drainage of the streets and lots impossible unless the subdivider agrees to make improvements which will, in the opinion of the Council, make the area completely safe for occupancy and provide adequate street and lot drainage. Subd.5.Partial Subdivisions: Where an owner or subdivider proposes to subdivide only a portion of owner's or subdivider's property, the Council may require the owner or subdivider to submit a preliminary plan indicating the proposal for subdividing the balance of the property so as to have proper relationship of streets and lot orientations with the portion to be subdivided and adjacent properties. SECTION 5.The City Council of the City of Mounds View hereby amends Title 1200, Chapter 1202, Section 1202.05 of the Mounds View Municipal Code by adding the double-underlined material as follows: 1202.05:NECESSARY DATA FOR FINAL PLAT: Subd.1.General: The final plat shall be prepared by a land surveyor who is registered in the State and shall conform to all State and County requirements and the requirements of this Title. Subd.2.Information to be Shown: a.All dimensions, including lot lines, shall be shown in feet and hundredths of feet. b.Accurate radii, internal angles, points and curvatures, tangent bearings and lengths of all arcs and accurate lineal dimensions for all lines, angles and curvatures used to describe boundaries, streets, alleys, easements, areas to be reserved for public use. c.When lot lines are not at right angle to the street right of way line, the width of the lot at the building setback line shall be indicated.