CC PACKET 02281989 - Laserfiche WebLink

Home Browse Search

GEMINI _._._ ,_-------- EQUIP-MEINT SPECIFICATIONS PAGE 5 OPTIONAL PLATFORM ACCESSORIES PLATFORM LINER To facilitate periodic electrical FIBERGLASS PLATFORM COVER Made of testing and provide additional insulation, a bucket molded fiberglass high gloss white finish.The cover liner is available for the one-man basket.These lin- fits over the platform rim and straps around the ers are constructed from low density polyethylene platform. Eliminates the sagging characteristic of with ultra violet inhibitor added. Each new liner is vinyl covers. Fiberglass platform covers are avail- tested at 50,000 volts AC RMS for one minute. The able for one-man platforms. liner has a minimum '/4" wall thickness. A PLATFORM TILT SYSTEM FOR SIDE-HUNG PLATFORMS provides for easy horizontal tilt by PLATFORM COVER A platform cover for the one- pulling pin and lifting a release lever.The tilt system man bucket is made from reinforced vinyl material enables ease of personnel rescue and basket debris which is waterproof and has exceptional resistance clean-out. to chafing and tearing. The cover is attached, by means of a drawstring, under the top lip of the FIBERGLASS TOOL TRAYS which attach to the basket. These covers are easily stored when not in upper edge of the platform and hang inside or out- use. side the platform can be provided by TECO. OTHER OPTIONAL EQUIPMENT EMERGENCY LOWERING PUMP INSTALLATION This emergency pump is not designed for continu- provides back-up power in case the truck engine or ous use, but only as an emergency back-up to the hydraulic pump fails. It enables the operator to main hydraulic system. lower the unit slowly to a folded position. The installation consists of a 12 volt DC electrical HYDRAULIC TOOL LINE INSTALLATION with hydraulic motor driven pump which operates off the truck battery,a hydraulic pressure switch,and a normally tool pressure lines and outlets studs at the platform and/or open relay activated by the safety powerlock system. base is a GEMINI option.%ff male quick disconnect studs for pressure and return outlets for connecting one(1)or If a pressure failure occurs in the hydraulic system, two(2)tools can be installed at the platform and/or bam the hydraulic pressure switch which is set at 400 psi activates the DC electric pump and the pump can then be activated by one of the safety powerlock actuators to lower the unit for travel.