Laserfiche WebLink
MINUTES <br />CITY COUNCIL <br />AUGUST 8, 1990 <br />Fahey felt the proposal offered by Blesener was too <br />great a departure from City standards. Fahey suggested <br />that Mr. Stewart pursue the City Engineer's cost <br />estimates with Mr. Buche. <br />Scalze stated that if it is the desire of the Council <br />to require less than a standard road for two or three <br />lots, then that should be adopted as a City policy and <br />applied fairly across the City. <br />Collova pointed out that the proposal is only for one <br />additional lot. Collova pointed out that Blesener's <br />proposal involved a public road, although the width was <br />narrower than standard and curb and gutter was not <br />proposed. <br />Fahey stated that he was willing to look at something <br />the City Planner could develop that would be applied <br />across-the-board in these situations. However, Fahey <br />did not feel City standards should be cut just so it is <br />feasible for Stewart to build. <br />Collova pointed out that it is not possible to develop <br />a policy that will fit every case, that is the reason <br />for the variance procedure. <br />Fahey agreed that the City's variance standards are <br />pretty tough. <br />RECESS At this point in the meeting, 9:00 P.M., the Council <br />took a short recess. The meeting was reconvened at <br />9:08 P.M. <br />STANKE The City Engineer reviewed correspondence outlining <br />WATERMAIN the need for watermain extension under Ryan Drive to <br />EXTENSION the Stanke property to serve a sprinkler system within <br />Mr. Stanke's building. The Engineer also outlined soil <br />conditions under Ryan Drive and the various <br />alternatives for installation of the watermain. The <br />Engineer pointed out that the most feasible alternative <br />involves floating the watermain on the peat and using <br />ball-joint pipe. Under those conditions, the Engineer <br />stated that the City could consider accepting <br />responsibility for the watermain. The Engineer pointed <br />out that 40 to 50 feet of ball-joint pipe would be <br />necessary, and this pipe is expensive. <br />Page 11 <br />