06-12-1985 Council Agenda - Laserfiche WebLink

Home Browse Search

C. Accessory enclosed retail, rental or service activity other than that allowed as a permitted use or Conditional use within this Section, provided that: 1. Such use is allowed as a permitted use in a "B -3" District. 2. Such use does not constitute more than ten (10) percent of the gross floor area of the_principal structure. 3. Adequate off - street parking and off - street loading in compliance with Sections 903.050 and 903.060 of this Ordinance are provided. 4. All signing and informational or visual communication devices shall be in compliance with Section 903.110 of this Ordinance. 5. The provisions of Section 921.010.0. of this Ordinance are considered and satisfactorily met. D. Industrial planned unit development as regulated by Section 923. of this Ordinance 50. LOT REQUIREMENTS ANDSETBACKS. The following minimum requirements shall be observed in an "1 - -P" District, subject to additional requirements, exceptions, and modifications set forth in this Ordinance. A. Lot Area: 40,000 square feet 8. Lot Width: 150 feet C. Setbacks: 1. Front Yards: Not less than fifty (50) feet. 2. Side Yards: Not less than twenty (20) feet on any one side, nor less than forty (40) feet on the side yard abutting a public street. 3. Rear Yards: Not less than thirty (30) feet. 4. Yards abutting residentially zoned property: Not less than forty (40) feet on any yard abutting residentially zoned property. D. Landscaping: All lots in an "I -P" District shall have not less than twenty -five (25) percent of the lot area dedicated to landscaped green area in compliance with Section 903.020.6. of this Ordinance. Landscape plans must be submitted to and approved by the City Council. E. Lot Coverage: No building or combination of buildings in the "1 -P" District shall exceed thirty -five (35) percent of the total lot area on which it is located. .060. BUILDING REQUIREMENTS A. Height: No building shall exceed forty (40) feet in height, except as provided below. B. Building Construction: 1. All buildings in the "I -P" District shall be constructed of solid wall masonry construction consisting of brick, stone, architectural concrete cast in place or pre -cast concrete panels on wall surfaces abutting a public right -of -way, residential districts, or public areas. Wood and metal exterior may be allowed as part of window and door frame treatments as well as a portion of the exterior wall facing design. 15 COMMENTS Sane as 1 -1 District. Limits the amount of retail area in the industrial—area. Same as 1 -1 District. Lot Area - double that of 1 -1 Lot Width - 50 feet more than 1 -1 Setbacks - most are increased. One of Ryan Industrial Park's main problems is the crowding of buildings onto minimum lots. COMMENTS New requirement - It should be noted that just the 5 foot strip along all property lines on the minimum "I -P" lot would exceed a 10 landscaped area. New requirement - Similar in intent to C and D above. Same as I -1 District. Metal building restriction - self explanatory. Permits only solid masonry construction, with allowances for facade treatments of metal or wood.