02-13-2017 Council Packet - Laserfiche WebLink

Home Search

8 2. The preliminary plat shall show lot widths and building setbacks measured to the Highway Easement/platted right-of-way lot line. 3. The lot lines shall extend straight north-south to the Highway Easement/platted right-of-way. Building Requirements At the time of building permit, each individual single family dwelling unit will be reviewed for compliance regarding floor area, garage and design and construction standards. Comment: 1. It should be noted on the preliminary plat that the angle of the proposed house on Lot 2 limits any future driveway access to the rear yard. Subdivision Ordinance Conformity with the Comprehensive Plan and Zoning Code The preliminary plat is consistent with the amended comprehensive plan for low density residential development and zoning code requirements for R-1X, Single Family Executive as discussed above. Per Section 1001.076(2), any subdivision that results in the creation of one or more sewered residential lots shall be platted in full compliance with preliminary plat and final plat requirements and therefore it is not a minor subdivision. Blocks and Lots The preliminary plat contains Lot 1 and Lot 2, Block 1 and no outlots. Per Chapter 1001: Subdivision Ordinance: Section 1007.007 Definitions: LOT FRONTAGE. The narrowest lot boundary abutting a public street that meets minimum lot width requirements. If none of the boundaries abutting a public street meet minimum lot width requirements, then the lot frontage is the widest boundary abutting a street. LOT LINE, FRONT. The lot line separating a lot from the street right-of-way along the lot frontage. LOT WIDTH. The horizontal distance between the side lot line of a lot measured at the front building setback line and parallel to the front lot line. If the front lot line is