Laserfiche WebLink
In 2018, a third garage stall was added onto the house located on Lot 1 (202 Elm St). Per <br />Section 1007.044(3)(h)16. Surfacing: All driveways shall be hard surfaced. The third <br />stall driveway shall be hard surfaced in accordance with the zoning ordinance. A zoning <br />permit is required. <br />Building Requirements <br />At the time of building permit, the single family house proposed on Lot 2 will be <br />reviewed for compliance regarding floor area, garage and design and construction <br />standards. <br />Subdivision Ordinance <br />The underlying plat is Lot 24, Auditor's Subdivision No. 151 that was platted in 1953. <br />Conformity with the Comprehensive Plan and Zoning Code <br />The preliminary plat and final plat are consistent with the comprehensive plan for low <br />density residential development and zoning code requirements for R-1, Single Family <br />Residential as discussed above. <br />Blocks and Lots <br />The final plat contains Lot 1 and Lot 2, Block 1, Bald Eagle Addition. As noted above, <br />Lot 1 contains the existing house and Lot 2 proposes a new single family home. <br />Streets and Alleys <br />Lot 1 is served by Elm Street which is a major collector road. The existing road right-of- <br />way width is 66 ft. Section 302.03(1)(a) requires 80ft of road right-of-way width. An <br />addition seven (7) ft of road right-of-way has been dedicated on the plat. <br />Lot 2 is served by Second Avenue which is also a major collector road requiring 80 ft of <br />road right-of-way width. The existing road right-of-way width is 80 ft. No addition <br />right-of-way is required. <br />Easements <br />Drainage and utility easements at least ten (10) feet wide are required and shown along <br />all lot lines. <br />Storm Water Management and Erosion and Sediment Control <br />Per the City Engineer's memo dated January 25, 2021, Bald Eagle Addition includes site <br />grading for the proposed house pad on Lot 2 and minimal site grading. Because the new <br />impervious surface of 4,257 sf is less than 10,000 sf, the project does not require <br />5 <br />