Laserfiche WebLink
Custom Fire Apparatus, Inc. <br />Specified upper level side compartments shall have fabricated vertical door jambs located above wheel <br />well enclosure, separating forward/upper level wheel well/rear compartment areas. Door jambs are to be <br />bolted to sweep -out threshold portion of upper level compartment opening and to the underside of <br />overhead compartment roof fabrication, easily removable so as to allow future modifications to door <br />opening size. <br />For maximum cubic footage of compartments, the lower portion of the interior forward side <br />compartments shall be recessed into within 4-inches of the chassis frame rail depth, both driver's side and <br />passenger's side of the apparatus body. Recessed areas to be full width of interior compartment, at least <br />30" high, occupying entire underbody area beneath the outboard portion of the tank. <br />BODY CORNER STYLE: <br />The front & rear driver side and passenger side body corners shall be as specified below. <br />The body corners shall have full height vertical front surfaces, and integral forward compartment door <br />jambs. <br />SWEEP OUT COMPARTMENT FLOORS: <br />Driver's side, passenger's side, and rear compartments shall be equipped with "sweep/wash-out" floors, <br />which are raised at least 1" above the compartment door opening threshold and exterior rub rail. All <br />running board/tailboard level side compartment door thresholds shall extend outboard, below the <br />compartment doors, with a minimum 3" flange -down (flush with body sides) and 1" return -in, providing <br />structure for mounting of the specified rub rail material. Door thresholds shall be bolted to and <br />removable from the interior raised compartment floors. <br />Upper level compartment floors, located above rear wheel well housings, are to be "sweep/wash-out" <br />design, fabricated of body material matching smooth sheet material. Upper level compartment door <br />bottom threshold shall be integral with the rear wheel well outer panel, positioned at least 1" below the <br />interior compartment floor surface, and lined with mirror finish stainless steel for doorway protection. <br />FRONT COMPARTMENT CORNERS, SQUARE SHAPE <br />The driver side and passenger side front body corners are to have a 90-degree "square" shape. Each <br />corner is to be a single piece full height fabrication, with integral inboard body mating flange (allowing <br />for removal), and outboard vertical door jamb. <br />REMOVABLE INTERIOR COMPARTMENT CORNER ALUMINUM WIRE COVERS <br />The passenger's side and the driver's side front and rear interior compartment corners (4-each) are to <br />include vertical full height/full depth wiring harness covers (bulkheads) which are bolted in position and <br />easily removable. Interior compartment corner wire covers are to be constructed of machine swirled <br />07/26/22 <br />- 107 - <br />