Laserfiche WebLink
Custom Fire Apparatus, Inc. <br />APPARATUS LIGHTING INSTALLATION STANDARDS: <br />All specified 12-volt to be in accordance with D.O.T. regulations at time of purchase. <br />WALKWAY, STANDING PLATFORM, AND WORK AREA LIGHTING <br />Specified standing, stepping, and walking surface lighting shall be located to minimize accidental <br />breakage. <br />LIGHTING INSTALLATION REQUIREMENTS <br />All specified light fixtures to be located/fitted prior to and re -installed after finish painting. Where fixture <br />wiring passes through metal body panel, the pass-thru hole to be equipped with a rubber grommet. All <br />specified light fixtures shall be installed, using stainless steel screws with non-metallic "replaceable" <br />threaded inserts, to allow removal of light fixture, from exterior of body. Where light fixtures are to be <br />installed on a painted panel, all light fixture mounting holes, grommet holes, and fastener holes shall be <br />machined/cut-out prior to prime and finish painting, so that all metal edge surfaces receive the same <br />protective coating. Where holes are cut or drilled, after finish painting, same holes shall receive paint <br />finishes prior to insertion of fasteners and threaded inserts. <br />FMVSS LIGHTING CONFIGURATION <br />The following specified rear body tail/stop turn and back up lights to be positioned: Red (tail/stop) TOP, <br />Amber (turn) MIDDLE, and Clear (back up) BOTTOM, driver's and passenger's side rear of body. <br />MASTER BATTERY SWITCH <br />See CHASSIS segment of specifications, for description, and location of provided master battery cut-off <br />switch. <br />REAR TAILBOARD STEP LIGHTS, LED <br />Two (2), 12-volt Grote model 60571 LED courtesy step lights are to be furnished, located to illuminate <br />tailboard step surface at the rear of the body. Light fixture to have polished stainless bezel and shielded <br />clear polycarbonate lens. Lights to be activated by parking brake set. <br />DOT LIGHTING <br />REAR LED ID/MARKER LIGHTING <br />Five (5), 3/4" LED marker lights to be furnished, located: two (2) recessed into outboard rear tailboard <br />corner flanges, and three (3) recessed behind center rear tailboard flange. Marker lights to be activated by <br />headlamp switch. <br />The three (3) LED marker lights located at the rear to be: <br />07/26/22 <br />- 141 - <br />