08-01-2022 Council Work Session Packet

Home Search

Each portion of the data shall be recorded at the specified intervals and stored for the specified length of time to meet NFPA 1901 guidelines and shall be retrievable by connecting a laptop computer to the VDR system. The laptop connection shall be a panel mounted female type B USB connection point, remotely mounted in the left side foot well. ACCESSORY POWER The electrical distribution panel shall include two (2) power studs. The studs shall be size #10 and each of the power studs shall be circuit protected with a fuse of the specified amperage. One (1) power stud shall be capable of carrying up to a 40 amp battery direct load. One (1) power stud shall be capable of carrying up to a 15 amp ignition switched load. The two (2) power studs shall share one (1) # 10 ground stud. A 225 amp battery direct power and ground stud shall be provided and installed on the chassis near the left hand battery box for OEM body connections. AUXILIARY ACCESSORY POWER An auxiliary set of power and ground studs shall be provided and installed behind the electrical center cover with a 40 amp breaker. The studs shall be 0.38 inch diameter and capable of carrying up to a 40 amp battery direct load. ADDITIONAL ACCESSORY POWER An additional six (6) position Blue Sea Systems 5025 blade type fuse panel shall be installed on the side wall of the engine tunnel behind the officer's seat. The fuse panel shall be protected by a 40 amp fuse. The panel shall be capable of carrying up to a maximum 40 amp battery direct load. An additional 4.00 feet of wire shall be provided for use by the apparatus builder. EXTERIOR ELECTRICAL TERMINAL COATING All terminals exposed to the elements will be sprayed with a high visibility protective rubberized coating to prevent corrosion. ELECTRICAL SYSTEM WARRANTY Purchaser shall receive an Electrical System Two (2) Years or 36,000 Miles limited warranty in accordance with, and subject to, warranty certificate RFW0202. The warranty certificate is incorporated by reference into this proposal, and included with this proposal or available upon request. ENGINE The chassis engine shall be a Cummins X12 engine. The X12 engine shall be an in -line six (6) cylinder, four cycle diesel powered engine. The engine shall offer a rating of 525 horse power at 1900 RPM and shall be governed at 2000 RPM. The torque rating shall feature 1695 foot pounds of torque at 1000 RPM with 720 cubic inches (11.8 liter) of displacement. The X12 engine shall feature a VGTTM Turbocharger, a high pressure common rail fuel system, fully integrated electronic controls with an electronic governor, and shall be EPA certified to meet the 2021 emissions standards using cooled exhaust gas recirculation and selective catalytic reduction technology. The engine shall include an engine mounted combination full flow/by-pass oil filter with replaceable spin on cartridge for use with the engine lubrication system. The engine shall include Citgo brand Citgard 500, or equivalent SAE 15W40 CK-4 low ash engine oil which shall be utilized for proper engine lubrication.