2003-060 Council Resolution - Laserfiche WebLink

Home Search

• 3. The driveway of Lot 7, Block 6 be shifted eastward to the extent possible. 4. The submitted townhome housing types and building elevations be modified to specify finish materials and be subject to City approval. Side walls facing public streets shall include windows or other architectural features to avoid the appearance of a blank wall. 5. Lots 1 -3, Block 4 shall be "airpark" lots. If these or other designated airpark lots are to be converted to non - airpark lots in the future, depending on the extent of changes to the design or configuration of the lots and roads, this could require replatting and a PUD amendment, at the City's discretion. 6. The applicant provide documentation to the City that all applicable runway safety requirements have or will be satisfied. The runway safety zone requirements are herebay established as a zoning restriction. As shown on the preliminary plat, the restricted area is measured from the edge of a 200' wide strip centered on the runway. At 126' from the edge, the maximum structure height is 18'. At 175' from this edge, the maximum structure height is 25'. The structure height maximum limit shall follow the slope of this imaginary surface and shall continue to extend over the development. 7. Specific hanger designs be submitted subject to City approval prior to consideration of the final plat approval of the lots with the hangers. 8. All homeowner association by -laws be subject to review and approval by the City Attorney prior to consideration of the final plat for lots where the association applies. 9. The wetland mitigation plan be subject to comment and recommendation by the City Engineer and Rice Creek Watershed District. All conditions imposed by the Rice Creek Watershed District shall be satisfied. The filling of land intended to be upland for park dedication must be accepted with the mitigation plan. 10. Park dedication shall include cash as well as land, shall include the trail across the 2 °d Addition to the eastern plat boundary, and include rough grading of the park land. Generally, park land shall be as indicated on the "Parks /Open Space" plan submitted in the April 2003 booklet. However, a new preliminary plat shall be submitted that clearly shows the park dedication lands, along with upland data for all areas intended to be dedicated as parkland. This data shall be reviewed to ensure acceptability prior to final plat approval. There must be a minimum of 4.5 (four and one -half) acres of contiguous upland useable for active recreation uses as determined by the Public Services Director, and a minimum of 7.0 (seven) acres total upland. The cash dedication may, at the City's discretion, be reduced by the cost of trail construction or other in -kind activities by the developer. Trail locations within the park areas shall be determined by the overall park design. The final park dedication shall be included in the development agreement, which must be reviewed by the City Council for approval.