Agenda Packets - 1994/03/14 - Laserfiche WebLink

Home Browse Search

D a Concrete iWiLa Surfacing, Inc. P.O. Box 185 • Rogers, Minnesota 55374 • (612)535-2644 • Fax (612)535-6934 PREPARATION A. The purpose of preparation is to open the surface creating a clean and dry profile in order to provide maximum adhesion/penetration of the coating system. B. Surface preparation is best achieved through the use of a steel shot blasting machine. It is a self-propelled and self-contained unit in which 95%of the steel shot is recovered and reused. Contaminates such as dirt, oil,coatings,spaulding,etc.are removed thereby creating a clean open surface. The unit also vacuums and retains all dirt, dust and debris from the removal making the process virtually dust free. CONDITIONS C. The area to be prepared for coating will not be walked on by anyone other than the floor preparer from the commencement of the job until the proper cure time has elapsed after the last application. This is very important and must be strictly enforced in order for the warranty to be valid. D. Building owner shall provide an electrician and power source:208/230 volt.3-phase.60 ami service to be connected 1/2 Hour prior to start of project and disconnect on completion. E. The building owner shall provide a dumpster suitable for the holding of removed floor materials and waste as well as empty product containers and other debris. Disposal of such items shall be the responsibility of the building owner, in accordance with federal, state, and/or local regulations. EXCEPTIONS F. This proposal does not include the moving of equipment,supplies,or other personal property from the area to be prepared or coated,nor the removal of paint overspray,concrete spillage,or stains,unless otherwise specifically stated in the work order. G. There may be products,ingredients or personnel in the facility that are subject to the absorption or inhalation of solvent odors. If so, it will be the responsibility of the owner or his agent to protect such products, ingredients or personnel from the solvents in the materials used in preparation and coating of the floor. H. There may be equipment,products or personnel in the facility that are subject to damage from dust or shot. If so,it will be the responsibility of the owner or his agent to protect such equipment,products or personnel from any dust or shot generated while preparing the floor for coating. WARRANTY *** P.S.I. Concrete Surfacing, Inc. warrants that all coatings and resurfacers applied pursuant to this agreement will not peel due to improper preparation and application for one year. This application warranty does not include damage to the coating from substrate failure,hydrostatic pressure,severe or abnormal use. This warranty and is in lieu of all other rights and remedies.