Laserfiche WebLink
<br /> <br /> <br />11 _________ <br /> Initial <br /> <br />Three (3) SCBA Wheel Well Bottle Storages <br />Three (3) SCBA bottle storages shall be installed above the rear wheel well. The shall <br />have One (1) on the left (driver) side of the polybody and Two (2) one the right (passenger) <br />side of the polybody, one (1) storage forward and one (1) backward of the rear wheels. <br />Each bottle storage shall have a polished aluminum hinged door with latch assembly. <br /> <br />The external face of the door shall be painted black. <br /> <br />Black Rubber Fenderettes <br />The rear wheel wells shall be radius cut with black rubber fenderettes installed at well <br />opening. <br /> <br />Black Rubber Rub Rail <br />A Poly black rubber rub rail shall be bolted on both sides of the body below the <br />compartment to protect the body from minor scrapes. <br /> <br />Fuel Fill Bezel <br />A fuel fill bezel shall be supplied and installed behind the rear wheels on the driver side of <br />the poly body. <br /> <br />Subframe <br />A stainless-steel subframe weldment shall be fabricated from tubing and formed sheet <br />metal to provide a mounting platform for the body side modules and the floor. There shall <br />be outriggers extending out and down from the sub frame to provide support to th e side <br />pack floors. There shall be a minimum of four (4) outriggers supporting each side module. <br />There shall be common attachment points along the length of the sub frame for mounting <br />it to the truck chassis. The finish on the subframe shall be painted black. <br /> <br />Body Header Panel <br />A formed .125” high smooth aluminum panel shall be provided at the front of the body and <br />shall extend the full width and height of the body to provide full frontal protection to the <br />body side modules. The header panel shall be fastened to both body side modules. Steel <br />cross members shall be installed at front. <br /> <br />The header shall be covered by Black Bed Liner. <br /> <br />Body Threshold Panel <br />Rear body side modules shall be jointed with a middle bottom bolted aluminum sheet <br />reinforced on four sides. <br /> <br />Handrails <br />Two (2) 12’’ access handrails shall be provided at the rear of the body, one (1) on each <br />side. Handrails shall be constructed of or covered with a slip-resistant, non-corrosive <br />material. Handrails shall be between 1in. and 1-5/8 in. in diameter and have a minimum <br />clearance between the handrails and any surface of at least 2 in. <br /> <br />Six (6) Rear Folding Steps <br />The rear of the body shall have Six (6) non-skid folding steps, three (3) on each side. <br />The rear steps shall be made so it can be folded up for use in rough terrain. All steps <br />shall sustain a minimum static load of 500 lbs. (227 kg) without deformation (NFPA 1906 <br />& 1901 compliant). The steps shall be black. <br />