Laserfiche WebLink
Custom Fire Apparatus, Inc. <br />The bumper shall be primed and painted as specified. <br />FRONT BUMPER EXTENSION LENGTH <br />The front bumper shall be extended approximately 31.00 inches ahead of the cab. <br />FRONT BUMPER PAINT <br />The front bumper shall be painted the same as the lower cab color. <br />FRONT BUMPER DISCHARGE <br />The chassis shall include two (2) frame mounted pipes intended for use as a discharge trash lines. There <br />shall be one (1) 2.00 inch diameter discharge pipe on the left hand and one (1) 2.50 inch diameter <br />discharge pipe on the right hand side routed from the left and right front splay rail area behind the <br />bumper to the area rear of the front axle, ahead of the battery boxes. <br />Each discharge pipe shall be stainless steel schedule 10 tube. The discharge shall include a Victaulic <br />groove for connecting to the pump and discharge hose plumbing on each end of the tube. <br />The apparatus manufacturer shall plumb the discharge pipes to the pump and shall provide all valves as <br />required. <br />MECHANICAL SIREN <br />The front bumper shall include an electro mechanical Federal Q2BTM siren, which shall be streamlined, <br />chrome -plated and shall produce 123 decibels of sound at 10.00 feet. The Q2BTM siren produces a <br />distinctive warning sound that is recognizable at long distances. A unique clutch design provides a longer <br />coast down sound while reducing the amp draw to 100 amps. The siren shall measure 10.50 inches wide <br />X 10.00 inches high X 14.00 inches deep. The siren shall include a pedestal mount to surface mount on a <br />horizontal surface. <br />MECHANICAL SIREN LOCATION <br />The siren shall be shipped loose for the body manufacturer to install. <br />AIR HORN <br />The front bumper shall include two (2) Hadley brand E-Tone air horns which shall measure 21.00 inches <br />long with a 6.00 inch round flare. The air horns shall be trumpet style with a chrome finish on the <br />exterior and a painted finish deep inside the trumpet. <br />AIR HORN LOCATION <br />The air horns shall be recess mounted in the front bumper fascia between the frame rails in the right and <br />left outboard positions. <br />AIR HORN RESERVOIR <br />One (1) air reservoir, with a 1200 cubic inch capacity, shall be installed on the chassis to act as a supply <br />tank for operating air horns. The reservoir shall be isolated with a 90 PSI pressure protection valve on <br />the reservoir supply side to prevent depletion of the air to the air brake system. <br />ELECTRONIC SIREN SPEAKER <br />07/26/22 <br />-33- <br />