Laserfiche WebLink
Custom Fire Apparatus, Inc. <br />ATTENTION: <br />A specific water tank spec and quote is required for final price. Replace this part and price with actual <br />tank for project. <br />WATER TANK PASS-THROUGH(S) FOR REAR DISCHARGE PIPING <br />The water tank shall have two (2) 4" i.d. pass -through PVC sleeve(s) extending horizontally through the <br />length of the water tank, to allow passage through the tank of discharge piping. Sleeve(s) shall be in line <br />with the exit location of the rear discharge(s). <br />WATER TANK OVERHANG, EXTENDING OVERHEAD FORWARD PUMP CAVITY <br />The water tank's front full width upper portion is to extended forward, "overhead" the pump mounting <br />cavity. Tank extension is to occupy the void space above pump and plumbing, thus reducing the tank top <br />height above ground level. <br />TANK SIDE WALL CONFIGURED FOR TANK -TO -PUMP SUCTION PLUMBING AND SUMP <br />The lower side wall of tank is to be provided with a female TIPT coupling, "flush" with the side wall of <br />tank, designed to accommodate the tank -to -pump suction piping. The coupling is to include internal tank <br />sump piping, and is to be compatible with an external tank hump hose connection, configured for use <br />with a compartment mounted engine driven pump. <br />A 10' x 10" bottom tank sump is to be provided, positioned so as to be inboard of the chassis frame rail, <br />extending at least three (3) inches below the tank bottom. <br />WATER TANK "MAXIMUM PRESSURE" DATA LABEL <br />The one (1) optionally specified Water Tank Re -Fill Inlet(s) to be furnished with permanently printed or <br />engraved Data Plate(s) to indicate the MAXIMUM ALLOWED TANK FILL INLET PRESSURE. <br />Inlet pressure is to be determined by the piping/valve size (inside diameter) and Tank Manufacturer's <br />Restrictions. Label(s) to be permanently encased in a chrome full surround bezel, located adjacent to the <br />inlet fitting(s). <br />DIRECT TANK FILL, 2.5" VALVE WITH 2.5" NST FEMALE INLET <br />LOCATION <br />There shall be one (1) 2.5" gated external tank fill furnished and properly labeled, installed on the driver's <br />side of the apparatus. <br />Piping, for the fill, shall be routed to the tank and include an interior tank flow deflector to "break up" the <br />stream of water entering the water tank. <br />07/26/22 <br />- 104 - <br />