08-01-2022 Council Work Session Packet

Home Search

have a fail of more than ten (10) squares. The pencil hardness test per ASTM D3363 shall have a final post -curved pencil hardness of H-2H. The direct impact resistance test per ASTM D2794 shall have an impact resistance of 120.00 inches per pound at 2 mils. FRAME ASSEMBLY STRUCTURAL Purchaser shall receive a Frame Assembly Structural Fifty (50) Years or 250,000 Miles limited warranty in accordance with, and subject to, warranty certificate RFW0305. The warranty certificate is incorporated by reference into this proposal, and included with this proposal or available upon request. FRAME RAIL CORROSION Purchaser shall receive a Frame Rail Corrosion (Zinc Plate and Powder Coat) Twenty Five (25) Years or 150,000 Miles limited warranty in accordance with, and subject to, warranty certificate RFW0316. The warranty certificate is incorporated by reference into this proposal, and included with this proposal or available upon request. FRAME COMPONENTS CORROSION Purchaser shall receive a Frame Components Corrosion (Zinc Plate) Twenty (20) Years or 132,000 Miles limited warranty in accordance with, and subject to, warranty certificate RFW0314. The warranty certificate is incorporated by reference into this proposal, and included with this proposal or available upon request. FRONT BUMPER The chassis shall include a formed channel front bumper. The bumper shall be constructed of 110 psi high strength low alloy steel. The bumper material shall measure 10.25 inches high with a 3.50 inch flange and shall be 0.38 inch thick and 104.50 inches wide, with 45.00 degree angled front corners. The bumper shall be primed and painted as specified. FRONT BUMPER EXTENSION LENGTH The front bumper shall be extended approximately 2 1. 00 inches ahead of the cab. FRONT BUMPER PAINT The front bumper shall be painted the same as the lower cab color. FRONT BUMPER APRON The 21.00 inch extended front bumper shall include an apron constructed of 0.19 inch thick embossed aluminum tread plate. The apron shall be installed between the bumper and the front face of the cab affixed using stainless steel bolts attaching the apron to the top bumper flange. FRONT BUMPER DISCHARGE The chassis shall include two (2) frame mounted pipes intended for use as a discharge trash lines. There shall be one (1) 2.00 inch diameter discharge pipe on the left hand and one (1) 2.50 inch diameter discharge pipe on the right hand side routed from the left and right front splay rail area behind the bumper to the area rear of the front axle, ahead of the battery boxes. Each discharge pipe shall be stainless steel schedule 10 tube. The discharge shall include a Victaulic groove for connecting to the pump and discharge hose plumbing on each end of the tube.