Laserfiche WebLink
Page 3 <br /> <br /> <br />a. Only land zoned as agricultural, rural residential, or rural estate may be considered for <br />establishment of an open space planned unit development. Requirement met. <br />b. The minimum land area for establishment of an open space planned unit development is a <br />nominal contiguous 20 acres. Requirement met. <br />c. Establishment of an open space planned unit development will be considered only for <br />areas of land in single ownership or control. Alternatively, multiple party ownership, in <br />the sole discretion of the city, is acceptable when legally sufficient written consent from <br />all persons and entities with ownership interest is provided at the time of application. <br />Requirement met. <br />Required vs. Proposed OP PUD Bulk Standards. Cells in the ‘As Proposed’ cells shaded in <br />Orange indicate a deviation from City Code. <br />Standards (105.12.1050) OP PUD Requirement: As Proposed <br /> <br />Minimum Lot Area 16,000 sq ft Range of 16,000 to 65,358 sq ft <br />Minimum Lot Width 100 feet 100 feet <br />Max Impervious Cover 30% per lot 40% per lot <br />Garage Frontage of Lot Maximum 40% of facade Maximum 60% of facade <br />Minimum Setback - Front 30 feet 30 feet <br />Minimum Setback - Side 15 feet 15 feet <br />Minimum Setback - Corner 30 feet 30 feet <br />Minimum Setback - Rear 20 feet 20 feet <br />Maximum Height 35 feet Not provided <br />Driveway Setback from <br />intersection <br />50 feet from r-o-w 50+ feet from r-o-w <br />Driveway setback from side <br />lot line <br />5 feet Driveway locations/widths not provided <br />Driveway Width 12-26 feet Driveway locations/widths not provided <br /> <br />Design Standards for OP PUDs. The following development standards are created for OP PUDs <br />by City Code Sec. 105.12.1050. For any standard not strictly met by the development, a <br />supermajority vote is required to approve the project: <br />(a) Density – City Code allows a maximum density in OP PUDs of 0.60 units per acre since at <br />least one access is designated as a collector road or higher. Requirement met at 0.53 units <br />per acre. <br />(b) Lot Design – Lot locations and configuration should be according to the following sequence <br />of review steps. <br />(1) Soils analysis conducted – Requirement met. <br />(2) Septic design identified - Requirement met. <br />(3) Buffer areas identified - Requirement met. <br />(4) Building pad locations identified - Requirement met. <br />(5) Placement of streets - Requirement met. <br />(6) Lots identified – see bulk standard review, above. Deviation requested for <br />impervious surface and architectural standards. <br />(7) Open Space and park land adjustments –